Wheel Chart

TreeDraw Standard Edition and TreeDraw Legacy Edition; our genealogy charting software.

Moderator: Nick Hunter

Post Reply
Posts: 1
Joined: Wed Sep 18, 2013 3:02 pm

Wheel Chart

Post by rbenbar » Wed Sep 18, 2013 3:12 pm

I am having trouble creating a wheel chart from my GEDCOM file. All I get is the one person in my tree and it is not in the Wheel format. I am selecting FILE, then Wheel Chart and then it takes me to my GEDCOM file to choose the name I wish to start with. I select that name and I only get a Rectangle block with the one person that I selected to start on the chart. Am using the Trial program currently.

Nick Hunter
Posts: 666
Joined: Sun Dec 18, 2005 9:36 am
Location: SpanSoft, Scotland

Re: Wheel Chart

Post by Nick Hunter » Wed Sep 18, 2013 5:20 pm


Sorry to hear that you are having problems with this.

I think there may be two possible causes for this.

First is that you have not selected "All" in "Generations".

Second is that there is a problem in the GEDCOM file and the person you have selected as the root does not have any ancestors. You can check this by importing an ancestral tree and using the same person as the root.

Post Reply